• Seametrics Flow Meter
  • Site Lab Ultrasonic Flow Meter
  • Siargo Gas Mass Flow Meter
  • VSE Positive Displacement Flow Meter
  • Tek Air HVAC Air Flow Meter
  • Gerand Fire Pump Test Flow Meter
  • Nanabosh Electrical Circular Connector
  • Sibas Heavy Duty Electrical Rectangular Connector
  • Daiwa Dengyo Electrical Safety Plug Connector
  • Gast Pneumatic Air Motor
  • Mecon Flow Meter
  • Rheonik Coriolis Mass Flow Meter
  • Sage Metering Thermal Mass Flow Meter

  • PHONE : +6285103019945, +628105062090, +6281282084779
  • FAX : +62-21-8855857
  • E-MAIL : Sales@wmablog.com
  • CONTACT : Ira, Kusuma dewi, Yati, Yugo




.Paddle Wheel Flow Meter IP-100 Series - Seametrics

The Seametrics IP100/200-Series are adjustable depth insertion paddlewheels that come in brass or 316 stainless models to ft 3” to 40” pipe. Installation fttings are standard 1-1/2" (101/201) or 2” (115/215) NPT. Fittings such as saddles and weldolets may be purchased either locally or from Seametrics.

Seametrics Paddle Wheel Flow Meter IP100

Two sizes fit entire pipe range: IP110 to 10", IP210 to 48"

High-quality ruby bearings for excellent low-flow performance and long life

Pickup exerts no magnetic drag on the rotor

One easily-replaced moving part

Square-wave frequency output can connect directly to PLC's or counter controls

Uses standard NPT threaded pipe fittings or saddles

Compatible with all Seametrics controls

Ruby bearings and a non-drag Hall-effect sensor give these meters the widest flow range of any of the paddlewheel types. A sensor detects the passage of miniature magnets in the six rotor blades. The resulting square-wave signal can be sent for hundreds of feet over unshielded cable without a transmitter and connected directly to many PLC’s and other controls without any additional
If desired, a modular system of electronics can be installed directly on the fow sensor or mounted remotely. The FT415 (battery powered) or FT420 (loop powered) fow indicator provides digital rate and total display, as well as programmable pulse output; the FT420 also provides a 4-20 mA analog output. If a display is not required, the AO55 provides 4-20 mA analog output, and the PD10 provides a programmable pulse for pump pacing.
The “hot-tap” models (IP115/215) can be installed or serviced without shutting down the line by means of a 2” full-port isolation valve that comes with a nipple for installation on the pipe ftting. In most circumstances, no special tool is required.

• Wide fow range
• One moving part
• Hot tap available
• Modular electronics compatible
• Easily depth adjustable for 3-40” pipe

• Clean water
• Large pipes
• Aquariums, water parks
• Water & wastewater monitoring




Download Data Sheet

Back to previous page (Kembali ke halaman sebelumnya)