• Seametrics Flow Meter
  • Site Lab Ultrasonic Flow Meter
  • Siargo Gas Mass Flow Meter
  • VSE Positive Displacement Flow Meter
  • Tek Air HVAC Air Flow Meter
  • Gerand Fire Pump Test Flow Meter
  • Nanabosh Electrical Circular Connector
  • Sibas Heavy Duty Electrical Rectangular Connector
  • Daiwa Dengyo Electrical Safety Plug Connector
  • Gast Pneumatic Air Motor
  • Mecon Flow Meter
  • Rheonik Coriolis Mass Flow Meter
  • Sage Metering Thermal Mass Flow Meter

  • PHONE : +62-851-0301-9945, +62-851-0506-2090, +62-812-8208-4779
  • FAX : +62-21-8855857
  • E-MAIL : sales@wmablog.com
  • CONTACT : Ira, Kusuma Dewi, Yati, Yugo




.Turbine Insertion Flow Meter TX-100 Series - Seametrics

The Seametrics TX100/200-Series are adjustable depth insertion turbines that come in brass or 316 stainless models to ft 3” to 40” pipe. Adapters mate with standard 1-1/2” (110/210) or 2” (150/250) FNPT threaded fttings such as saddles and weldolets which may be purchased either locally or from Seametrics.

Seametrics Turbine Flow Meter TX100 Series

Two sizes fit entire pipe range: TX110 to 10", TX210 to 48"

Turbine rotor to optimize minimum flow limits

High quality ruby bearings for long life

One easily-replaced moving part

Square-wave frequency output can connect directly to PLC's or counter controls

Uses standard NPT threaded pipe fittings or saddles

Compatible with all Seametrics controls

Bidirectional indication available as option

Ruby bearings and a non-drag pickoff give these adjustable insertion turbine fow sensors a wide fow range and long life.
A sensor detects the passage of miniature magnets in the rotor blades. The resulting square-wave signal can be sent for hundreds of feet without a transmitter, over unshielded cable.
This signal can be connected directly to many PLC’s and other controls without any additional electronics.If desired, a modular system of electronics can be installed directly on the fow sensor or mounted remotely. The FT415 (battery powered) or FT420 (loop powered) provides digital rate and total display, as well as programmable pulse; the FT420 also provides a 4-20 mA analog output. The AO55 is a blind analog (4-20 mA) transmitter. Programmable pulse for pump pacing is available with the PD10.
The “hot-tap” models (TX150/250) can be installed or serviced without shutting down the line by means of a 2” full-port isolation valve that comes with a nipple for installation on the pipe ftting. In most circumstances, no special tool is required.

• Wide fow range
• One moving part
• Hot tap available
• Modular electronics compatible
• Easily depth adjustable for 3-40” pipe

• Clean water
• Large pipes
• Aquariums, water parks
• Water & wastewater monitoring



Download Data Sheet

Back to previous page (Kembali ke halaman sebelumnya)